Worldwide shipping · SS 304 / 316 / 202

DIN 933

DIN 933 Stainless Steel Hex Bolts (Full Thread)

DIN 933 is the standard for hex head bolts threaded along the full length of the shank, and the ISO equivalent is ISO 4017. We make them in stainless steel in metric sizes, in SS 304, SS 316 and SS 202. Send size, length and grade for a quote.

Sizes and variants we supply

Grades and property classes

What DIN 933 covers

DIN 933 covers hex head bolts that are fully threaded from the head to the tip, which makes them useful when the joint needs thread over the whole length. It sets the head and across-flats dimensions, thread tolerances and length tolerances. Thread is metric coarse unless fine pitch is stated. Because the thread runs to the head, the bolt is usually chosen for thin clamped parts or where adjustment is needed.

Typical applications

Equivalent standards and differences

ISO 4017 is the international equivalent of DIN 933 and its dimensions are very close, so the two are often treated as interchangeable. DIN 933 has been replaced by ISO 4017 in the DIN EN ISO form, but the DIN number remains common in trade. DIN 931 is the partial thread bolt, covered on its own page. For inch series bolts, the American equivalents follow ASME dimensions. Check your drawing for the exact standard.

How to specify DIN 933 on a purchase order

Write the standard, size, length, grade and quantity, for example: DIN 933 M10 x 50 A2-70 hex bolt, 5,000 pieces. Add the finish, packing needs and destination country. If your drawing calls out ISO 4017, mention it and we confirm the match. We confirm availability, the standard and which documents we can provide before you place the order. Sending a drawing, sample or clear photo with your enquiry helps us match the part faster and avoids mistakes.

Why source from Ayr SS Nut Bolt

Frequently asked questions: DIN 933 Stainless Steel Hex Bolts (Full Thread)

A DIN 933 bolt is a hex head bolt with thread running along its full length up to the head. Its ISO equivalent is ISO 4017. We supply it in stainless steel in SS 304, SS 316 and SS 202, in metric sizes, and we confirm availability before you order.

The ISO equivalent of DIN 933 is ISO 4017. Dimensions are very close, and DIN 933 was replaced by the ISO version, though the DIN number is still widely used when ordering. If your drawing names one of them, tell us and we confirm what we can supply.

DIN 933 bolts are threaded along the full length, while DIN 931 bolts have a plain shank section with thread only at the end. Choose full thread for thin parts and adjustment, and partial thread when the shank should carry shear load.

Choose SS 304 (A2) for general indoor and outdoor use, and SS 316 (A4) for marine, coastal or chemical exposure. SS 202 suits mild environments where cost matters. Tell us the application and the strength class you need, and we suggest a grade.

Yes. We supply a range of lengths and make made-to-order sizes against drawing. Send the diameter, length and quantity and we confirm what we can supply before you order. If no drawing exists, a sample or clear measurements can be used.

Send the size, length, grade, quantity and destination by email to ayrssnutbolt@gmail.com or call +91 89196 74214. We confirm availability, the standard and the documents we can provide before an order is placed, then pack the goods for export by sea or air.

Request DIN 933 bolts

Send us the standard, grade, size and quantity. We confirm availability, the standard and the documents we can provide before you order.

Accepted file types: pdf, jpg, jpeg, png, dwg, dxf, xls, xlsx, doc, docx, Max. file size: 10 MB.