Worldwide shipping · SS 304 / 316 / 202

DIN 931

DIN 931 Stainless Steel Hex Bolts (Partial Thread)

DIN 931 is the standard for hex head bolts with a plain shank and thread only on the end portion, and the ISO equivalent is ISO 4014. We supply them in stainless steel, in SS 304, SS 316 and SS 202. Send size, length and grade for a quote.

Sizes and variants we supply

Grades and property classes

What DIN 931 covers

DIN 931 covers hex head bolts with an unthreaded shank and a threaded portion at the tip. The plain shank carries shear loads and locates the joint, while the thread length depends on diameter and bolt length. For typical lengths up to 125 mm the thread length is 2d plus 6 mm. Bolts shorter than the minimum length for partial thread are normally made fully threaded, to DIN 933.

Typical applications

Equivalent standards and differences

ISO 4014 is the international equivalent of DIN 931 and its dimensions are very close. DIN 931 has been replaced by ISO 4014 in the DIN EN ISO form, but the DIN number stays common in trade. DIN 933 is the full thread version, with ISO 4017 as its equivalent. For inch series, ASME dimensions apply. Always check the standard named on your drawing before ordering.

How to specify DIN 931 on a purchase order

Write the standard, size, length, grade and quantity, for example: DIN 931 M12 x 80 A4-70 hex bolt, 2,000 pieces. Add the finish, packing needs and destination country. If your drawing names ISO 4014, mention it and we confirm the match. We confirm availability, the standard and which documents we can provide before an order. Sending a drawing, sample or clear photo with your enquiry helps us match the part faster and avoids mistakes.

Why source from Ayr SS Nut Bolt

Frequently asked questions: DIN 931 Stainless Steel Hex Bolts (Partial Thread)

A DIN 931 bolt is a hex head bolt with a plain shank and thread only on the end part. Its ISO equivalent is ISO 4014. We supply it in stainless steel grades SS 304, SS 316 and SS 202, and confirm availability and documents before you order.

The ISO equivalent of DIN 931 is ISO 4014. The dimensions are very close, and DIN 931 was replaced by the ISO version, though trade still commonly uses the DIN number. Tell us which standard your drawing names and we confirm what we can supply.

Use DIN 931 when the plain shank should carry shear load or locate the joint. Use DIN 933 when full thread is needed, for example with thin parts or where adjustment is required. Both are covered on our standards pages and we supply both.

No. Thread length depends on diameter and bolt length. For lengths up to 125 mm it is 2d plus 6 mm, where d is the thread diameter. Send your size and length and we confirm the part we would supply before you place the order.

SS 304 (A2) suits general use, SS 316 (A4) suits marine, coastal and chemical exposure, and SS 202 suits mild environments. Tell us the application and the strength class you need, and we suggest a grade and confirm what we can supply.

Send the size, length, grade, quantity and destination to ayrssnutbolt@gmail.com or call +91 89196 74214. We confirm availability, the standard and the documents we can provide before you order, and we pack the goods for export by sea or air.

Request DIN 931 bolts

Send us the standard, grade, size and quantity. We confirm availability, the standard and the documents we can provide before you order.

Accepted file types: pdf, jpg, jpeg, png, dwg, dxf, xls, xlsx, doc, docx, Max. file size: 10 MB.