Worldwide shipping · SS 304 / 316 / 202

A2-70, A4-80: How to Read Stainless Steel Fastener Markings

Engineering blueprints

Stainless steel bolts and screws are usually marked on the head with a code such as A2-70 or A4-80. This code comes from ISO 3506 and tells you two things: the steel family and the strength class.

The first part: A2 and A4

The letter A means austenitic stainless steel. The number that follows is the alloy group. A2 is the group that covers grades such as 304. A4 is the group that includes molybdenum-bearing grades such as 316, which resist chlorides better.

The second part: 50, 70, 80

The number after the hyphen is the property class. Multiply it by 10 to get the minimum tensile strength in megapascals.

  • Class 50: soft condition, 500 MPa minimum tensile strength. Common for nuts and lightly loaded parts.
  • Class 70: cold-worked, 700 MPa. The most common class for bolts and screws.
  • Class 80: highly cold-worked, 800 MPa. Used where higher strength is needed.

Example

A bolt marked A4-70 is an austenitic, molybdenum-alloyed stainless bolt (316 type) with a 700 MPa minimum tensile strength. It suits strong, corrosion-resistant joints in marine or chemical use.

Why it matters

When you order, state both the grade and the property class, for example A2-70 hex bolts to DIN 933. That removes doubt and makes sure the fasteners match the design load and the environment.

Share this article

Keep Reading

Related Articles