Worldwide shipping ยท SS 304 / 316 / 202

Home  /  Technical Data

Technical Data

Grades, property classes, manufacturing methods and key terms for stainless steel fasteners.
Grades

Austenitic Stainless Steel: A2 and A4

Austenitic (300 series) stainless steel makes up the large majority of stainless fasteners. A2 is the group that includes SS 304. A4 includes SS 316, which adds molybdenum for better resistance to chlorides.

SS 304 (A2)

General-purpose grade for food and dairy equipment, breweries, pharma, pulp and paper, electronics, architecture, swimming pools (non-chlorinated), pollution control and general engineering.

SS 316 (A4)

Contains nickel and molybdenum. Suited to chemical plants, marine and offshore equipment, textile and bleach processes, acid plants, photographic and rubber industries.
Chemical Composition

Typical Composition by Grade

GradeCSiMnPSCrNiMo
A2 (304)0.081.002.000.0450.03018 – 208 – 10.5–
A4 (316)0.081.002.000.0450.03016 – 1810 – 142 – 3

Maximum percentages unless a range is shown. Typical values for guidance only.

Strength

Property Classes (ISO 3506)

Property classMin. tensile strengthMin. 0.2% proof strengthCondition
50500 MPa210 MPaSoft
70700 MPa450 MPaCold-worked
80800 MPa600 MPaHighly cold-worked

Values for bolts and screws per ISO 3506-1. Confirm against the current standard for your design.

Manufacturing

Cold Forging and Hot Forging

Cold Forging

Metal is shaped at room temperature in dies. Used for smaller diameters. Gives tight tolerances, a smooth finish, good grain flow and an efficient process for large volumes.

Hot Forging

The bar is heated until soft and then forged. Used for larger diameters where cold forming is impractical. Makes heavy sizes possible, followed by machining and threading.

Glossary

Key Terms Explained

The maximum pulling stress a fastener can withstand before it breaks.

The stress at which a fastener begins to deform permanently. Stainless fasteners are rated by 0.2% proof strength.

A specified test load a fastener must carry without permanent deformation.

A chemical treatment that removes free iron from the surface and helps the protective chromium oxide film form.

A thin, invisible chromium-rich oxide layer that protects stainless steel from corrosion and self-heals when scratched in air.

Increase in strength and hardness as metal is deformed. Austenitic stainless steels work-harden strongly, which is why cold-forged parts can be stronger.

Annealed austenitic stainless steel is non-magnetic. Cold forming can make it slightly magnetic, which does not mean it is lower in quality.

Seizure of stainless threads under load. Reduce the risk with lubrication, moderate speed when tightening and mixed grades where suitable.