Studs are threaded at both ends or along the full length, and are used where a bolt head is not practical, such as flanges, pumps, valves and heat exchangers. Fully threaded bars are cut to length for anchoring, hanging and structural work.
We supply studs and threaded bars in a very wide size range, in full thread and partial thread, and can cut or make them to the length you need.
SS 304, SS 316, SS 202
3 mm to 90 mm
3/16 inch to 3 inch
Up to 3 metres
Full thread and partial thread
On request
Typical standards: DIN 975 (threaded rod) and DIN 976 (stud bolts).
A stud is a shorter rod, often threaded at both ends or fully, made for a specific joint. A threaded bar is a long, fully threaded rod supplied in standard lengths and cut to suit.
Yes. Give us the diameter, thread length and overall length and we will quote cut-to-length studs or bars.
Stud bolts for pipe flanges and pressure joints.
Studs that allow repeated assembly.
Reliable fastening in hot and wet service.
Threaded bars cut to length for supports.